If you're like me, you don't particularly care to use Compound Clips if you can get away with it...
I don't work much with 360º, but I have done some work with it and I have been fighting those seam lines on and off for some time. Last night, based on a new trick I learned a couple months ago, I thought I'd give this solution a try. It seems to be helpful.
I am assuming you are referring to the "artifact lines" that occur at the 180º angle and I am familiar with the problem. Below I have examples of the problem:
Original (not very "sharp" and no sign of the "seam" problem):

Some sharpening/color effects added — seam appears at exactly the 180º mark:

After Fix Seam 360: (Remove Seam setting at 20)

Original:

After sharpening/color effects:

After adding Fix Seam 360 (setting about 50):

Fix Seam 360 is **very lightweight**, and only one parameter (Remove Seam). Apply it *after* you apply effects that cause the lines to appear. I recommend that you try to find a parameter value less than the default (50). Larger values than 50 are available for use, but may create a partially noticeable region of "reflection" at the edge (but far...far less noticeable than the full length seam.) For example:
After sharpening/color effects and Fix Seam 360 at 50:

Going higher than 50 splits this chair into two slices... the seam is gone, but so is part of the chair — just something to be careful about (and may sometimes be unavoidable!)

Free download here:
https://fcpxtemplates.com/?sdm_process_download=1&download_id=32570
Hope you find it useful!