Unofficial archive. This is a read-only, community-run archive of the Apple Support Community. It is not affiliated with or endorsed by Apple Inc.

Advice needed on optimizing and reducing the complexity of a large FCPX project

I'm working on a large FCPX project with loads of compound clips and Multicam clips. I'd like to replace video edits of Multicam sequences with original footage clips (but keep the audio) to reduce the project size and complexity.


When I select a Multicam clip in the timeline and search for the original clip in the browser and then the file, I'm taken to the Multicam clip not the source file. Is there a way to drill down farther and get to the original clips? I then want to use them instead of the large Multicam clips.

4 replies

You can get back to the original clip but I haven't found a quick way.


Once you match frame the multicam shot to its multicam clip in the browser by pressing shift+F, note the timecode, then double-click the multicam clip to open it in the angle editor. Press control+p and enter the timecode you noted. That will place the playhead at the correct point in time. Then select the angle that contains the shot you're trying to match frame to and move the skimmer so it lines up with the playhead. Press shift+F to match frame back to the original clip.

The functionality to collapse the multicam project is not available in FCP as it was in the legacy software. I encourage you to make a feature request for this. It is a very useful and important function for multicam work.

Thanks Terry. I will definitely try this out.

Thanks Tom, will do.